1.

Attach corner leg supports (Fig. 1) to the outer structural frame members with the supplied bolts and wing nuts. (Fig. 2)

Fig. 1

Fig. 2

2.

Place one of the center leg supports in the bed within easy reach. (Fig. 3) Lift one side of the TruckDeck into the bed. (Fig. 4)

Fig. 3

Fig. 4

3.

Position the first half of the TruckDeck into its correct horizontal orientation, (Fig. 5) and use the center leg support to hold the TruckDeck in position. (Fig. 6)

Fig. 5

Fig. 6

4.

Lift the remaining TruckDeck half into the truck (Fig. 7) and move it into position lowering the center seam onto the center leg support. (Fig. 8)

Fig. 7

Fig. 8

5.

Secure the two halves of the TruckDeck together by fastening the two inner frame members together through the predrilled holes with the supplied bolts and wing nuts. (Fig. 9) Place the front and rear structural support members at each end of the TruckDeck. (Fig. 10)

Fig. 9

Fig. 10

6.

Fasten the forward structural support to the underside of the TruckDeck (Fig. 11) then secure the rear frame member with the supplied bolts and wing nuts. (Fig. 12)

Fig. 11

Fig. 12

7.

Install the rear hatch by aligning the predrilled holes with the preinstalled hinges on the TruckDeck and secure with included bolts and wing nuts. (Fig. 13) Attach the rear hatch gas springs to the ball studs on the hatch door and on the rear support. (Fig. 14)

Fig. 13

Fig. 14

8.

Secure the fully assembled TruckDeck to your truck by connecting the turnbuckles to your factory installed tie-downs. (Fig. 15) The TruckDeck should have approximately 0.25” of separation from the bed walls around the entire perimeter. Once your TruckDeck is securely fastened you are ready to place your Load-N-Go containers and hit the road! (Fig. 16)

Fig. 15

Fig. 16